<div dir="ltr">I am monitoring the exact same UPS on my OmniOS box, with NUT configured as per the old Oracle blog - however I have it connected through a network interface.<br><br>If you have issues with connecting it via USB, I suggest you consider adding a network card which is likely to be much easier to get up and running.<br>
</div><div class="gmail_extra"><br><br><div class="gmail_quote">On 2 June 2014 13:29, Paul B. Henson <span dir="ltr"><<a href="mailto:henson@acm.org" target="_blank">henson@acm.org</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
So I've got an older APC Smart-UPS 1500 which I'd like to monitor from<br>
omnios via usb. I plugged it into one of my linux boxes just to verify<br>
how it presented the usb interface, and NUT said:<br>
<br>
driver = "usbhid-ups"<br>
        port = "auto"<br>
        vendorid = "051D"<br>
        productid = "0002"<br>
        product = "Smart-UPS 1500 RM FW:617.3.D USB FW:1.5"<br>
        serial = "AS0411320933"<br>
        vendor = "TRIPP LITE"<br>
        bus = "002"<br>
<br>
So I believe NUT should support it with the standard hid driver. I went<br>
looking for how to setup usb ups support under omnios, and didn't find<br>
too much. Most of the results for Solaris talk about forcing the device<br>
to use the ugen driver rather than the hid driver, but I found some<br>
posts on the NUT mailing list saying that's not really needed anymore,<br>
and you should be able to monitor it as a hid device.<br>
<br>
At this point, I've got it plugged in, and it shows up as:<br>
<br>
usb3/1.2                       usb-input    connected    unconfigured ok<br>
<br>
usb3/1.2                       connected    unconfigured ok         Mfg:<br>
American Power Conversion  Product: Smart-UPS 1500 RM FW:617.3.D USB<br>
FW:1.5  NConfigs: 1  Config: 0  : 1<br>
<br>
It looks like it's connecting as a HID device, although it's showing up<br>
as unconfigured. I haven't installed NUT yet, so maybe it will be as<br>
simple as running it and the device will be automagically configured and<br>
start working ;). But while I'm spinning up NUT, I wanted to see if<br>
there was any more up to date advice on how to monitor a usb hid type<br>
ups under omnios.<br>
<br>
Thanks...<br>
<br>
_______________________________________________<br>
OmniOS-discuss mailing list<br>
<a href="mailto:OmniOS-discuss@lists.omniti.com">OmniOS-discuss@lists.omniti.com</a><br>
<a href="http://lists.omniti.com/mailman/listinfo/omnios-discuss" target="_blank">http://lists.omniti.com/mailman/listinfo/omnios-discuss</a><br>
</blockquote></div><br></div>